Color steel plate has become more and more the darling of the construction industry, not only because it has more advantages, of course, the characteristics of color steel plate itself cannot be ignored.

Color steel plate is a relatively economical and environmentally friendly material, which can be disassembled and repaired. The assembly and disassembly are convenient and simple. The standard unit wall panels can be interchanged, which is very convenient for maintenance of water and electricity and line transformation. In addition, the surface of the color steel plate can be opened arbitrarily, which is very convenient for installing switches, power sockets and other equipment. We can see that the color of the surface of the color steel plate is soft, and it forms a unified and harmonious whole with the floor, with a modern flavor. In particular, the electrostatic spray paint is used in the spraying process to make the surface of the color steel plate smooth and delicate, without dust accumulation, and simple to maintain, which to a large extent guarantees the cleanliness requirements of the machine room. The color steel plate has also passed the level test, meets the national fire protection standard, and can fully meet the fire protection requirements of the construction and decoration of the computer room.

Precautions for installation of color steel plate:

When installing the wall panel, first transport the wall panel to the vicinity of the installation point, and then place the metal panel upright. This can be done with a suction cup, and then place the lower end of the color steel plate on the skirting board. The two sides of the lining board are close to the vertical keel, and the distance between one side and the other wall board is 12mm, and then the self-tapping screws are fixed on the vertical keel. The fixed distance is between 300mm-400mm. During the assembly process, always pay attention to whether the installation is horizontal or vertical. When you reach the last wall panel, if it is necessary to cut, please use the correct method to cut and trim according to the measured size, and then install it on the wall.

Use the "U"-shaped inner corner edge finishing strip for edge finishing. Custom-made color steel plates can be used for corners and pillars, which are both beautiful and generous. Another thing to note is that in order to make the corners consistent with the wall, professionally retouch the corners of the wall to use the same color.

The above is the relevant knowledge of color steel plate, I hope it will be helpful to everyone!